Separation of Monovinyl and Divinyl Protochlorophyllides Using C30 Reverse Phase High Performance Liquid Chromatography Column: Analytical and Preparative Applications

A new, high performance liquid chromatography method has been developed for the separation of monovinyl- and divinyl-protochlorophyllides, using commercially available, C₃₀ reverse phase column and isocratic elution. This method can be used both for analytical applications and preparative scale purification of monovinyl- and divinyl-protochlorophyllides using the same column where submilimolar concentrations of the crude protochlorophyllide extract can be separated in one run. The purity of the obtained protochlorophyllides was demonstrated by spectroscopic methods, as well by the formation of aggregates in toluene.     

X-ray photoelectron spectroscopy characterization of composite TiO2–poly(vinylidenefluoride) films synthesised for applications in pesticide photocatalytic degradation

X-ray photoelectron spectroscopy (XPS) was adopted for the analytical characterization of composite titanium dioxide–poly(vinylidenefluoride) (TiO₂–PVDF) films developed for applications in the photocatalytic degradation of pollutants.

The composites were deposited on glass substrates by casting or spin coating from TiO₂–PVDF suspensions in dimethylformamide (DMF). XPS data on the TiO₂–PVDF surface composition were used to optimize preparation conditions (composition of the TiO₂/PVDF suspension, deposition technique) in terms of titanium dioxide surface amount and film stability.

The use of spin-coating deposition and the increase of TiO₂ amount in the DMF suspensions were found to improve the titanium surface content, although high TiO₂/PVDF ratios led to film instability. PVDF–TiO₂ films were also used in preliminary photocatalytic degradation tests on isoproturon, a phenylurea herbicide, under solar UV irradiation; the results were compared to direct photolysis to evaluate the catalytic efficiency of immobilized TiO₂ and the role played by the PVDF film during the degradation process.     

A note on an SOR-like method for augmented systems

Golub et al. (2001, BIT, 41, 71–85) gave a generalizedsuccessive over-relaxation method for the augmented systems.In this paper, the connection between the SOR-like method andthe preconditioned conjugate gradient (PCG) method for the augmentedsystems is investigated. It is shown that the PCG method isat least as accurate (fast) as the SOR-like method. Numericalexamples demonstrate that the PCG method is much faster thanthe SOR-like method.     

Thermal transformations of selected transition metals oxyhydroxides

We investigated the features of the glass transition relaxation of two room temperature ionic liquids using DSC. An important observation was that the heat capacity jump, that is the signature of the glass transition relaxation, shows a particularly strong value in this type of new and promising materials, candidates for a range of applications. This suggests a high degree of molecular mobility in the supercooled liquid state. The study of the influence of the heating rate on the temperature location of the glass transition signal, allowed the determination of the activation energy at the glass transition temperature, and the calculation of the fragility index of these two ionic glass-formers. It was concluded that this kind of materials belong to the class of relatively strong glass-forming systems. This revised version was published online in July 2006 with corrections to the Cover Date.     

A novel greener glycosidation using an acid-ionic liquid containing a protic acid

The glycosidations of glucopyranosyl diethyl phosphite and alcohols using an ionic liquid, 1-n-hexyl-3-methylimidazolium trifluoromethanesulfonimidide (C₆mim[NTf₂]) containing a protic acid, trifluoromethanesulfonimide (HNTf₂), as a novel solvent-catalyst system, effectively proceeded under mild conditions to give the corresponding glycosides in good to high yields. Furthermore, this acid-ionic liquid combination could be reused many times for the glycosidations without any loss in efficiency.     

The Fundamental Experiments of Red Tide Chemical Forecast

Many food algae and red tide algae were cultivated in the f/2 medium, and the nitric oxide (NO) concentration of the medium and the cell density were determined. The experiments on algae were conducted when different concentrations of NO were added into the medium using two methods. The results show that low concentrations of NO were self-produced by marine algae during the exponential growth period and were about nmol/L level. But at the end of the period, i.e., 2 or 3 days before the cell density reaches the maximum, an NO peak appeared, with the NO concentration reaching 10 nmol/L. The NO threshold concentration exists according to the influence of exogenous NO on the marine phytoplankton growth. One type is the threshold concentration that can promote algae growth, and its value is between 10 and 1 nmol level, or even lower. The other type can inhibit the phytoplankton growth, which is about μmol level or higher. The results indicate that red tide algae are far more sensitive to NO than are food algae. The fundamental experimental outcome above may provide a new clue for red tide chemical forecast by inspecting the NO change.     

Separation and determination of m-phenoxybenzaldehyde reaction products by capillary gas chromatography

A capillary GC method employing an internal standard has been developed and successfully used for quantitative determination both of the raw materials used for the manufacture of m-phenoxybenzaldehyde and for the components of the reaction mixtures obtained at various stages of the development of the process. A complete analysis can be performed in a single temperature programmed run.     

结构—饱和土壤相互作用的固结有限元分析

讨论了结构与饱和土壤相互作用的固结分析问题.对于结构利用多重子结构分析技术实现向饱和土交界面上的凝聚.从而建立了结构与饱和土壤相互作用的固结控制方程.文中给出了问题求解的一次性算法方案,采取压力主从关系的手段处理边界上的不排水条件.文末给出数值算例.本文工作为大型结构与土体相互作用固结分析研究工作的深入创造了条件.     

Influence of heat treatment conditions on the porosity changes of sulfonated styrene/divinylbenzene copolymers

Sulfonic cation exchangers with two ion exchange group concentrations (0.5 and 2.4 mmol/g, samples A and B, respectively) were obtained by sulfonation of a porous styrene (S) and divinylbenzene (DVB) copolymer with chlorosulfonic acid. Strong thermal decomposition of the sulfonated copolymer A, accompanied by significant changes in its porous structure, starts at ca. 400°C. The char has no sulfonic groups. After heat treatment at 400°C in steam, a sorbent was obtained (yield 65%) that shows higher phenol sorption than the untreated sample when related to the bed volume. The chlorosulfonic derivatives of the initial copolymer were less thermally resistant than the sulfonic ones obtained by hydrolysis. Pyrolysis of the cation exchanger B, in its H+ and Ca²⁺ forms, was carried out at 900°C (yield of both chars close to 30%). By subsequent steam activation at 800°C to a 50% burn-off of the char, sorbents with well-developed, but distinctly different, porous structures were obtained. The activated char from the sulfonated copolymer in its hydrogen form was highly microporous and indicated an effective surface area of 1180 m²/g. However, because of a low contribution of mesopores, its ability to adsorb phenol from the liquid phase was not very high. The activated char from the calcium-doped copolymer, indicating a smaller surface area (580 m²/g) but characterized by a well-developed mesoporosity, was a better sorbent for phenol. © 1994 John Wiley & Sons, Inc.     

(a,b,n)-临界图的几个充分条件

设G是一个图 .设g和f是两个定义在V(G)上的整值函数使得对V(G)所有顶点x有g(x) ≤f(x) .图G被称为 (g ,f,n) 临界图 ,如果删去G的任意n个顶点后的子图都含有G的 (g ,f) 因子 .本文给出了图是 (a ,b ,n) 临界图几个充分条件 ,即度和邻域条件 .进一步指出这些条件是最佳的 .